BS 7504:1995 Hydraulic fluid power. Four-screw, one-piece square flange connections for use at pressures of 25 MPa and 40 MPa (250 bar and 400 bar)
Withdrawn
Printed version of this is available at library. To request, please e-mail to referencepk@usm.my and include a copy of this record in your e-mail.
This International Standard gives complete general
and dimensional specifications for four-screw, one-
piece square-flange connections for use at pressures
of 25 MPa and 40 MPa (250 bar) and 400 bar).
For flange connections, a design factor of 2,5 is valid,
not including weld joints, for which special in-
structions exist.
This International Standard also specifies the dimen-
sions of the seals to be used, as well as the grooves
to house the seals.
These connections are intended for application in hy-
draulic systems, on industrial and commercial prod-
ucts, where it is desired to avoid the use of threaded
connections.
Surges of pressure higher than the nominal ratings
will reduce the ability of the flange connections to re-
tain the hydraulic fluid and this should be taken into
account in the design of the hydraulic system.