Dalam projek prasiswazah ini, papan litar bercetak (PCB) untuk pencampur penukar tinggi
Telah direka untuk berfungsi pada frekuensi RF2.5GHz dengan menggunakan cip MAX2671dari
MAXIM. Rekabentuk ini adalah berdasarkan model kit penilaian MAX2671 sebagai rujukan. Em
pat kaedah penting digunapakai dalam merekabentuk PCB ini, iaitu padanan impedans, penen
tuan lebar jalur kuprum, rekabentuk susun atur PCB dan pengekstrakan elemen parasit (RLC).
Rangkaian padanan berbentuk L dilakukan dengan menggunakan komponen tergumpal untuk
memadankan PCB ini terhadap ciri impedans 50 Ω. Pulangan kehilangan, S11, yang diperoleh
adalah lebih kurang -27 dB. Memandangkan projek ini ada kaitan dengan signal frekuensi radio
(RF), lebar laluan penghantaran yang diperoleh ialah 1.84 mm dengan menggunakan papan
RO3003. Susun atur PCB direka dengan menggunakan topologi rekabentuk 2 lapisan me
mandangkan litar ini hanya memerlukan 11 biji komponen sahaja dan oleh sebab itu, dimensi
PCB yang diperoleh ialah 52.1×48.76 mm. Elemen parasit yang wujud dalam laluan mikrostrip diekstrak. Keputusannya, nilai kapasitan dan aruhan yang diperoleh mempunyai perbezaan se
banyak 8 hingga 39 % apabila nilai kiraan masing-masing dibandingkan dengan nilai simulasi
yang sepadan. Hal ini menunjukkan bahawa elemen parasit memang wujud walaupun frekuensi
yang digunakan hanya 2.5 GHz dan oleh sebab itu, kesan RLC dalam papan RF mesti dititikber
atkan.
_______________________________________________________________________________________________________
In this undergraduate project, a PCB for an upconverter mixer is designed to operate at
RF frequency of 2.5 GHz using MAXIM’s MAX2671 chip. The design is based on MAX2671
evaluation kit model as the reference. Four important methods have been used in designing
the PCB which are characteristic impedance matching, copper trace width determination, PCB
layout design and parasitic elements (RLC) extraction. An L-section matching network using
lumped components is done to match the PCB to characteristic impedance of 50 Ω. The return
loss, S11, obtained is about -27 dB. Since this project is related to RF signals, the transmission
line width is found to be 1.84 mm by using RO3003 board. The PCB layout is designed using
2-layer design topology since the circuit requires only 11 components and thus the dimension of
the PCB is 52.1×48.76 mm. The parasitic elements that exist in the microstrip line are extracted. As a result, capacitance and inductance is found to have between 8 to 39% difference when their
respective calculated values are compared with the equivalent simulated values. This shows that
parasitic elements do exist although the frequency used is only 2.5 GHz and therefore the effect
of RLC in RF boards must be considered.