MS 62196-2:2013 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories (IEC 62196-2:2011, MOD)
Printed version of this standard is available at Library. To request, please e-mail to adminpk@usm.my and include a copy of this record in your e-mail.
This Malaysian Standard is applicable to plugs, socket-outlets, vehicle connectors and vehicle inlets with pins and contact-tubes of standardised configurations, herein referred to as accessories. They have a nominal rated operating voltage not exceeding 500 V a.c., 50 Hz to 60 Hz, and a rated current not exceeding 63 A three-phase or 70 A single phase, for use in conductive charging of electric vehicles.
This standard covers the basic interface accessories for vehicle supply as specified in MS IEC 62196-1, and intended for use in conductive charging systems for circuits specified in MS IEC 61851-1:2010.
Electric vehicles covers all road vehicles, including plug-in hybrid road vehicles (PHEV), that derive all or part of their energy from on-board batteries.
These accessories are intended to be used for circuits specified in MS IEC 61851-1:2010 which operate at different voltages and frequencies and which may include ELV and communication signals.
These accessories may be used for bidirectional energy transmission (under consideration).
This standard applies to the accessories to be used in an ambient temperature of between -30°C and +50°C.
These accessories are intended to be connected only to cables with copper-alloy conductors.
Vehicle inlet and vehicle connector to this standard are intended to be used for charging in modes 1, 2 and 3, cases B and C. The socket-outlets and plugs covered by this standard are intended to be used for charging mode 3 only, cases A and B.
The modes and permissible connections are specified in Part 1.
Primary Item Type:
Malaysian Standard
Identifiers:
ICS 29.120.30
ICS 43.120
Standard Number MS 62196-2:2013
ISC ISC E - Generation, Transmission and Distribution of Energy
Language:
English
Subject Keywords:
Electric vehicles; EV; Plugs; Socket-outlets; Vehicle connectors; Vehicle inlets
First presented to the public:
6/20/2018
Original Publication Date:
6/4/2013
Previously Published By:
Department of Standards Malaysia
Place Of Publication:
Cyberjaya, Selangor
Citation:
Extents:
Note - Correspondence to International Standard: IEC 62196-2:2011, Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories
MS 62196-2:2013 Plugs, socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 2: Dimensional compatibility and interchangeability requirements for a.c. pin and contact-tube accessories (IEC 62196-2:2011, MOD)
