Projek ini membentangkan antena yang direkabentuk berdasarkan geometri Sierpinski gasket iaitu mikrojalur (antena tampal). Rekabentuk tersebut telah dihasilkan melalui CST Microwave Studio. Untuk memperolehi cirri-ciri multijalur frekuensi, antena tersebut direkabentuk sehingga iterasi ketiga. Prestasi antena diperhatikan dari segi frekuensi resonansi dan perubahan kehilangan kembali mengikuti bilangan iterasi yang ditetapkan. Apabila iterasi Sierpinski gasket meningkat, ia tidak dapat menunjukkan radiasi yang berkesan disebabkan aliran arus yang tidak seimbang. Pengubahsuaian telah dilakukan kepada iterasi yang tinggi dengan memperkenalkan penampalan gandingan supaya aliran arus dapat diseimbangkan. Peningkatan hasil telah ditunjukkan melalui graf S11. Fabrikasi telah dilaksanakan menggunakan FR4 substrat yang ketebalan 1.6mm, pemalar dielektrik 4.5, dan tangent kehilangan 0.025. Hasil prototaip pada iterasi ketiga telah menunjukkan cirri-ciri multijalur yang bergema pada 3.700 GHz, 7.435 GHz, 7.930 GHz, dan 8.650 GHz dengan kembali hilang -11.53 dB, 18.80 dB. -26.03 dB dan -40.21 dB masing-masing. Perbezaan peratusan antara frekuensi resonansi simulasi dan ukuran adalah kurang daripada 3% yang menunjukkan keputusan theori dan praktikal adalah sepadan.
___________________________________________________________________________________
This project presents the design of a type of fractal antenna, which is Sierpinski gasket patch. The design of this fractal antenna is done by using CST Microwave Studio. In order to get the multiple bands of resonant frequencies (multiband) behavior, three iterations of Sierpinski gasket patch have been designed. The performance of the antenna is investigated through the resonant frequencies and return loss according to the number of iterations. When the iteration of Sierpinski gasket patch antenna has increased, it did not radiate effectively due to uneven current distribution. Modification is done by introducing coupling patches at higher iterations to provide low resistance conducting path for the current that attempts to penetrate into the upper part of the structure. Improvement on the result is shown through the S11 parameter graph. Fabrication has been carried out using FR4 substrate with thickness, dielectric constant and loss tangent of 1.6mm, 4.5 and 0.025 respectively. The hardware prototype of the
3rd iteration shows a multiband behavior that resonates at 3.700 GHz, 7.435 GHz, 7.930
GHz, and 8.650 GHz with the return losses of -11.53 dB, -18.80 dB. -26.03 dB and 40.21 dB respectively. The percentage difference between the simulated and measured resonant frequency is less than 3% showing that both of the results are theoretically and practically matched.