Penjerapan adalah kaedah yang paling biasa dan meluas yang digunakan untuk rawatan air dan air sisa disebabkan oleh proses yang ekonomik, senang untuk dioperasi dan cekap. Tujuan kajian ini adalah untuk menilai prestasi penjerap lapisan nipis bentonit-polisulfon untuk penyingkiran pewarna. Terdapat beberapa parameter yang telah diuji untuk prestasi penjerapan iaitu nisbah bentonit-PSf, kepekatan awal larutan pewarna, nilai pH, suhu dan kelajuan pencampuran. Ia didapati bahawa nisbah bentonit-PSf yang sesuai adalah 0.5:0.5. Kepekatan awal adalah berbeza-beza untuk 50, 100, 150 dan 200 mg/L. Terdapat juga beberapa nilai-nilai pH yang diuji iaitu 3,5,7,9 dan 11. Manakala bagi suhu pula, ia diubah kepada 30, 40, 50 dan 60oC. Perbezaan kelajuan pencampuran ialah 0, 120, 240 dan 360 rpm di mana ianya tidak memberi banyak kesan kepada prestasi penjerapan. Peratusan penyingkiran MB juga boleh mencapai sehingga 99% untuk setiap parameter. Data keseimbangan disimulasikan dengan menggunakan model Langmuir, Freundlich dan Temkin isoterma. Pemodelan kinetik hanya sesuai dengan persamaan perintah pseudo- kedua. Penemuan mendapati bahawa potensi penjerap lapisan nipis bentonit-polisulfon sebagai bahan penjerap untuk teknologi rawatan air sisa pada masa depan.
_______________________________________________________________________________________________________
Adsorption is the most common and broadly used method for water and wastewater treatment due to the economic process, ease of operation and efficient. The purpose of this study is to evaluate the performance of bentonite-polysulfone thin layer adsorbent for dye removal. There were a few of parameters that was tested for the adsorption performance which is bentonite-PSf ratio, initial concentration of dye solution, pH value, temperature and mixing speed. It was found that the suitable bentonite-PSf ratio is 0.5:0.5. The initial concentrations were varied for 50, 100, 150 and 200 mg/L. There are a few of pH values that were tested which are 3,5,7,9 and 11. While for the temperature, it was varied to 30, 40, 50 and 60oC. The differences of mixing speed which is 0, 120, 240 and 360 rpm did not give much affect to the adsorption performance. The percentage of MB removal can achieve up to 99% for each parameters. Equilibrium data were plotted using Langmuir, Freundlich and Temkin isotherm models. Kinetic modelling was fitted only to the pseudo-second order equation. The finding acknowledged the potential of bentonite-polysulfone thin layer adsorbent as an adsorbent for future wastewater treatment technology.