Penulenan silikon memainkan peranan yang sangat penting dalam pencapaian
spesifikasi dan kadar pembersihan yang mencukupi dalam aspek-aspek aplikasinya.
Melalui hubungan kerjasama dengan pihak industri, membran polyvinylidenedifluoride
(PVDF) and polytetrafluoroethylene (PTFE) digunakan untuk menulen air secara mikro
dari silikon resin. Faktor-faktor yang menjejas prestasi dari pengurangan kandungan air
di silikon adalah suhu, kandungan air, tekanan dan karakteristik dari membran.
Mengikut hasil daripada penulenan air secara mikro, pengurangan kandungan air di
silikon dapat dicapai secara memuaskan apabila operasi tersebut dilakukan pada
tekanan rendah dan suhu tinggi, atau sebaliknya. Membran PTFE memberikan hasil
yang lebih baik dalam aspek penulenan S250 tetapi diungguli oleh membran PVDF
untuk penulenan S500 disebabkan kandungan air yang lebih tinggi. Membran-membran
yang digunakan dalam kajian ini dicirikan oleh pengukuran sudut sentuhan air, SEM
dan FTIR. Hasil daripada pencirian tersebut membuktikan bahawa membran PTFE
lebih unggul berbanding membran PVDF dalam aspek hidrofobik yang ditunjukkan
oleh nilai 130.29 ± 0.30° dan 101.50 ± 0.24°. Pengurangan aspek hidrofobik juga terjadi
pada membran yang telah disalut dengan silikon. Analisa SEM dilakukan pada bahagian
keratan rentas dan pandangan atas membran menunjukkan bahawa membran PVDF
disalut silikon dalam jumlah yang kecil dan secara sepenuhnya untuk membran PTFE.
Penentuan struktur kimia untuk membran PVDF dan PTFE juga dilakukan dalam kajian
ini.
_______________________________________________________________________________________________________
Silicone purification has become a paramount importance in ensuring the
achievement of appropriate properties and sufficient chemical purity in diverse
applications. In this industrial collaborative work, polyvinylidenedifluoride (PVDF) and
polytetrafluoroethylene (PTFE) membranes are proposed for the microfiltration of water
in silicone resin. Major aspects that pose influence on water rejection performance are
temperature, moisture concentration, pressure and membrane characteristics. The
filtration results showed that adequate water rejection is achieved for PVDF membrane
under high temperature at low operating pressure or the opposite case. PTFE membrane
allows better performance on water rejection for purifying S250 but further dominated
by PVDF membrane for S500 due to higher moisture concentration. The respective
membranes were further characterized with contact angle measurements, SEM and
FTIR. The characterizations showed that PTFE is dominant over PVDF in terms of
membrane hydrophobicity which was represented by the value of 130.29 ± 0.30 and
101.50 ± 0.24°, respectively. A reduction in fouled membrane surface hydrophobicity is
also observed. Fractured cross sections and the upper surface of the membranes were
observed with SEM which showed a slight and complete fouling phenomenon on PVDF
and PTFE membrane. Lastly, determination of membrane chemistry and the associated
chemical structure of fresh PVDF and PTFE membranes were conducted as well.