MS IEC 60309-2:2013 Plugs, socket-outlets and couplers for industrial purposes - Part 2: Dimensional interchangeability requirements for pin and contact-tube accessories (IEC 60309-2:2005, IDT)
Printed version of this standard is available at Library. To request, please e-mail to adminpk@usm.my and include a copy of this record in your e-mail.
This Malaysian Standard applies to plugs and socket-outlets, cable couplers and appliance couplers with a rated operating voltage not exceeding 690 V, 500 Hz and a rated current not exceeding 125 A, primarily intended for industrial use, either indoors or outdoors.
This standard applies to plugs and socket-outlets, cable couplers and appliance couplers with pins and contact tubes of standardized configurations.
This standard applies to plugs and socket-outlets, cable couplers and appliance couplers, hereinafter referred to as accessories, for use when the ambient temperature is normally within the range -25 °C to 40 °C.
The use of these accessories on building sites and for agricultural, commercial and domestic applications is not precluded.
This standard applies to accessories with screwless type terminals or insulation piercing terminals, with a rated current up to and including 16 A for Series I and 20 A for Series II.
Socket-outlets or appliance inlets incorporated in or fixed to electrical equipment are within the scope of this standard. This standard also applies to accessories intended to be used in extra-low voltage installations.
Primary Item Type:
Malaysian Standard
Identifiers:
Standard Number MS IEC 60309-2:2013
ICS 29.120.30
ISC ISC E - Generation, Transmission and Distribution of Energy
Language:
English
Subject Keywords:
Plugs; Socket-outlets; Couplers
First presented to the public:
6/20/2018
Original Publication Date:
6/4/2013
Previously Published By:
Department of Standards Malaysia
Place Of Publication:
Cyberjaya, Selangor
Citation:
Extents:
Number of Pages - 76
Note - Correspondence to International Standard: IEC 60309-2:2005, Plugs, socket-outlets and couplers for industrial purposes - Part 2: Dimensional interchangeability requirements for pin and contact-tube accessories
MS IEC 60309-2:2013 Plugs, socket-outlets and couplers for industrial purposes - Part 2: Dimensional interchangeability requirements for pin and contact-tube accessories (IEC 60309-2:2005, IDT)
MS IEC 60309-2:2013 Plugs, socket-outlets and couplers for industrial purposes - Part 2: Dimensional interchangeability requirements for pin and contact-tube accessories (IEC 60309-2:2005, IDT)