Kajian ini menerangkan tentang persediaan dan ciri-ciri hidrofobik poly (vinylidene flourida) membran melalui kaedah songsangan fasa menggunakan sistem dual penggumpalan. Terdapat dua jenis pelarut yang digunakan dalam formulasi ini seperti dimetilformamida (DMF) dan dimetilacetamida (DMAc). Kesan-kesan masa untuk larut, kepekatan polimer, nisbah isopropanol/air dan jenis-jenis pelarut ke atas sudut sentuh membrane dikaji. Morfologi-morfologi dan kebolehbasahan PVDF membran disiasat dengan menggunakan Mikroskop Daya Atom (AFM) dan pengukuran sudut sentuh (CA). Struktur nodul membran-membran diperolehi dengan merendam ke dalam tempat isopropanol yang tulen. Seterusnya, untuk meningkatkan membran hidrofobisiti, membran disediakan dengan menggunakan DMF yang telah direndam ke dalam tempat penggumpalan yang pertama untuk 4s diikuti dengan air untuk satu hari. Semakin bertambah kandungan isopropanol dalam tempat penggumpalan itu, semakin bertambah sudut sentuh untuk larutan DMF-PVDF. Mikroskop Daya Atom (AFM) menunjukkan membran yang terendam ke dalam tempat penggumpalan isopropanol boleh menyebabkan liang membran lebih kecil dan seragam.
___________________________________________________________________________________
This study describes the preparation and characterization of hydrophobic poly(vinylidene flouride) membrane by phase inversion method using dual coagulation bath system. There are two solvents that used in this formulation namely dimethylformamide (DMF) and dimethylacetamide (DMAC). The effects of immersion time, polymer concentration, isopropanol/water ratio and solvent types on membrane contact angles were studied. The morphologies and wettability of PVDF membrane were investigated using Atomic Force Microscopy (AFM) and contact angle (CA) measurement. The defined nodular structures of membranes were obtained by immersed into pure of isopropanol bath. To further increase membrane hydrophobicity, membrane prepared using DMF were immersed into the first coagulation bath for 4s followed by water bath for 1 day. By increasing the isopropanol content in the coagulation bath, the contact angle increase significantly for DMF-PVDF solution. Atomic Force Microscopy (AFM) image show that membrane immersed in pure isopropanol coagulation bath resulted in membrane with smaller and uniform pores.