Pada abad ke-21 ini, salah satu keprihatinan dan perhatian yang diberikan adalah dalam bidang kualiti tenaga elektrik yang diedarkan. Terdapat beberapa piawaian antarabangsa diwujudkan untuk mengurangkan pembebasan harmonik daripada bekalan kuasa mod AC-DC. Untuk memenuhi piawaian-piawaian, pembetulan faktor kuasa adalah sangat diperlukan. Dalam tradisi pembetulan faktor kuasa untuk bekalan kuasa mod suis, kebanyakannya adalah menggunakan pengawal analog. Tetapi, kemajuan dalam teknologi pembuatan peranti digital telah membawa perubahan kepada tradisi analog ini di mana pengawal digital yang berkuasa tetapi tidak mahal, dapat bersaing dengan pengawal analog. Dalam projek ini, teknik kawalan digital untuk pembetulan factor kuasa menggunakan algoritma sedia-kira dengan mikropengawal 8-bit kos rendah dibentangkan. Dalam aplikasi teknik ini, kitaran tugas bagi tempoh separuh kitaran talian AC dikira “offline” dan disimpan ke dalam memori peranti. Faktor kuasa berhampiran 1 dapat dicapai berdasarkan pemadanan nilai talian voltan AC dengan nilai paparan jadual di dalam memori. Kebaikan menggunakan teknik ini adalah ia tidak memerlukan pengukuran arus elektrik dan juga peranti digital yang mahal. 1 litar rekaan untuk pembetulan faktor kuasa telah disediakan dengan dikawal oleh mikropengawal 8-bit. Keputusan simulasi dan eksperimen menunjukkan trend positif, di mana teknik yang dicadangkan dapat membantu meningkatkan faktor kuasa hampir ke kesatuan.
______________________________________________________________________________________
In this 21st century, the quality of electric power distributed to us has become a concern and attention. There are few international standards of harmonic emission made for the AC-DC switched mode power supply. To fulfill these standards, power factor correction is very needed. In tradition, analog controller is used for implementation in power factor correction in switched mode power supply. But, the progress in the manufacturing technologies of digital devices has changed the situation, where the low cost yet powerful digital controllers can be challenging the analog controllers in improving power factor. Digital control technique for power factor correction using pre-calculated algorithm with low cost 8-bit microcontroller is presented in this paper. Based on this, duty cycles for half line period are computed offline and then stored into device’s memory. Nearly unity power factor can be achieved based on synchronization of AC voltage line with look up table in the memory. The benefit of using this technique is that it doesn’t require us to measure the current and also doesn’t need to use powerful and expensive digital device. A prototype of boost power factor converter circuit which is controlled by the 8-bit microcontroller, is set up to implement the technique proposed. Both simulation and experimental results show positive trend, indicating that the technique proposed can achieve unity power factor.