Panel solar atau juga dikenali sebagai modul fotovolta (PV) menukar tenaga
cahaya daripada Matahari kepada tenaga elektrik. Modul ini boleh disambung secara siri
atau selari untuk membentuk tatasusunan PV yang dapat membekalkan lebih kuasa.
Sistem PV bersambungan grid merupakan satu sistem di mana kuasa yang dijana oleh
tatasusunan PV dibekalkan kepada grid utiliti. Pada suatu sinaran dan suhu tertentu, hanya
terdapat satu titik pada hubungan arus-voltan (I-V) panel solar di mana panel solar
beroperasi pada kuasa yang maksimum. Oleh sebab panel solar dikehendaki beroperasi
pada titik kuasa maksimum (MPP) pada setiap masa, sistem penjejakan titik kuasa
maksimum (MPPT) telah diperkenalkan. Dalam projek ini, sistem PV bersambungan grid
satu fasa disimulasi menggunakan MATLAB dan Simulink. Sistem PV bersambungan
grid terdiri daripada tatasusunan PV, penukar Boost, penyongsang, dan penapis. Penukar
Boost digunakan untuk meningkatkan voltan keluaran tatasusunan PV. Penyongsang
digunakan untuk menukarkan voltan DC kepada voltan AC pada kekerapan grid. Penapis
digunakan untuk menghasilkan bentuk gelombang voltan AC yang sinus tulen dengan
menghapuskan harmonik. Algoritma pengusikan dan pemerhatian (P&O) digunakan
untuk mencapai MPPT. Sistem PV ini disimulasi di bawah keadaan sinaran yang berbeza
dan kesan terhadap sistem tersebut diperhatikan.
_______________________________________________________________________________________________________
Photovoltaic (PV) modules convert the light energy from the Sun into electrical
energy. They can be connected in series or parallel to form PV arrays that can supply
more power. A grid-connected PV system is a PV system whereby the power generated
by the PV arrays are supplied to the utility grid. At any particular irradiance and
temperature, there is only one point on the current-voltage (I-V) characteristics of the PV
array where the array operates at maximum power. As it is desirable to operate the PV
array at the maximum power point (MPP) at all times, Maximum Power Point Tracking
(MPPT) has been developed. In this project, a single-phase grid-connected PV system is
simulated using MATLAB and Simulink. The grid-connected PV system consists of a PV
array, a Boost converter, an inverter and a filter. The Boost converter steps up the output
DC voltage of the PV array. The inverter converts the output DC voltage of the Boost
converter to an AC voltage of grid frequency. The filter is used to produce a purely
sinusoidal AC voltage waveform by eliminating the higher-order harmonics. The Perturb
and Observe (P&O) algorithm is used to achieve MPPT. The system is simulated under
different irradiance conditions and the effects are observed.