Penukar at merupakan litar elektronik yang menukar sumber arus terus dari satu aras
ke aras yang lain. Penukar ini boleh menaikkan, menurunkan atau membalikkan keluaran.
Tujuan utama dalam menjalankan projek ini adalah untuk merekabentuk penukar at dengan
menggunakan topologi Boost dengan keluaran 100 W, 24 V. Ujian dan analisa pada
rekebentuk ini dilakukan dengan menggunakan perisian PSIM 4.5 dan ia akan dibandingkan
dengan keputusan eksperimen. Voltan keluaran untuk penukar at dengan topologi Boost
ditentukan oleh kitar tugas yang mana nisbah masa suis terbuka kepada masa keseluruhan
suis berfungsi. Kitar tugas ini dihasilkan oleh pemodulatan lebar denyut. Litar pemodulatan
lebar denyut tersebut diaplikasikan untuk mengawal MOSFET bagi menjamin keluaran
yang tetap teratur. Berdasarkan keputusan ujikaji, litar pensuisan boleh menghasilkan
pemodulatan lebar denyut dengan kitar tugas dari 0.1 hingga 0.8 pada frekuensi tetap iaitu
10 kHz. Hingar yang terhasil daripada IC 555 Timer telah dikurangkan dengan
menggunakan pemacu MOSFET TC 4427.
__________________________________________________________________________________
Dc converter is an electronic circuit which converts a source of direct current (DC)
from one voltage level to another. They can step-up, step-down, and invert. In this project
the main objective is to develop 100 W, 24 V Dc converter by using Boost topology. The
simulation and analysis of the design is done by using PSIM 4.5 software and compare with
the experimental result. The output voltage of the boost dc converter is determined by the
duty cycle which is the ratio of the switch on-time to the entire switching cycle time. A duty
cycle is generated by a pulse-width modulator (PWM). The PWM control circuit drives the
MOSFET to ensure a constantly regulated output. Based on the experiment, the switching
circuit can generate a PWM with duty cycle from 0.1 to 0.8 at fixed frequency of 10 kHz.
The noise from output of the IC 555 Timer is eliminates by using Driver MOSFET TC4427.