Florida wujud di dalam kandungan air secara umumnya, sama ada dalam bekalan air
atau air kumbahan. Florida tidak akan memberi kesan buruk kepada manusia dan
hidupan lain sehingga kepada satu amaun tertentu sahaja dan untuk amaun yang lebih
besar atau lebih tinggi daripada1.0 mg/l, florida bukan lagi sebagai satu keperluan.
Daripada sesetangah kajian yang dijalankan, didapati had keperluan florida bagi
manusia dan haiwan adalah sangat rendah. Oleh kerana itu, keperluan terhadap kajian
dalam mencari bahan penjerap terbaik sebagai ejen penyingkiran kandungan florida
yang tinggi adalah penting. Kebanyakan kajian – kajian terdahulu menunjukkan
bahawa penjerapan merupakan kaedah yang terbaik untuk menyingkirkan florida
sehingga 95% keberkesanannya dan didapati penjerapan pengelompokan adalah cara
yang digemari untuk digunakan. Projek ini mengetengahkan produk – produk hasil
buangan kelapa sawit seperti sabut, habuk, tempurung dan abu sebagai bahan yang
sesuai dan berpotensi, malah menjimatkan bagi tujuan penyingkiran florida. Projek ini
juga menggunakan penjerapan berkelompok dan kesemua bahan penjerap telah
dirawat menggunakan asid. Kajian ini mendapati, abu adalah bahan penjerap yang
paling berkesan bagi menyingkirkan florida pada pH 2 dan ujikaji ini telah dijalankan
selama 240 minit masa kisaran. Tiga model utama yang sesuai dengan penjanaan
isoterma adalah model Freundlich, model BET dan model Langmuir. Kajian ini
mendapati bahawa Isoterma Langmuir mematuhi penjerapan florida dengan berkesan
dan model Langmuir dipilih kerana nilai R2 yang tertinggi sekali. Kecekapan
penyingkiran yang dicapai oleh abu adalah dalam 92.5 %.
_______________________________________________________________________________________________________
Fluoride is commonly found in water and wastewater. Fluoride would not cause any
bad impact to human and other life nature, up to certain amount only and for some
higher amount or more than 1.0 mg/l, fluoride is no more as a requirement. From
some studies, the permissible limits of fluoride for both humans and animals
requirement was found to be very low. Therefore, the needs of studies to search for
the best adsorbent, as an agent to remove high amount of fluoride is important. Most
of the previous studies shown that adsorption is the best way to remove fluoride
almost up to 95 % effectiveness and found that batch adsorption seems to be the
favourite method to be used. This project is highlighted on oil palm waste such as
fibre, sawdust, shell and ash as suitable and potential, yet economical materials for the
purpose of fluoride removal. This project also used batch adsorption and all adsorbent
were treated with acid. This study found that ash is the most effective adsorbent to
remove fluoride at pH 2 and the experiment were carried out for about 240 minutes
agitation time. Three main models suits with the isotherms generation are Freundlich
model, BET model and Langmuir model. The present study found that Langmuir
Isotherm followed the Fluoride adsorption effectively and the Langmuir was chosen
due to the highest value of R2. The efficiency of removal achieved by ash as the
adsorbent is about 92.5 %.