Tujuan projek ini adalah untuk membina sebuah prototaip yang boleh menjana
elektrik dengan menggunakan sistem yang bergerak. Bahagian yang bergerak diperbuat
daripada magnet dan gegelung. Beberapa magnet diletakkan di pemutar. Bagi
memastikan pemutar tersebut terus berputar, arus elektrik perlu melalui solenoid.
Solenoid itu dibuat dengan penggulungan gegelung pada gegelung kili dan di isi dengan
teras besi di tengah-tengahnya. Oleh itu, sebuah litar di bina bagi membolehkan
pergerakan arus daripada bateri kuasa untuk melalui solenoid dan pada masa yang sama,
bateri lain akan dicas semula. Prototaip ini dibina berdasarkan tiga ciri. Ciri mekanikal,
elektrik dan elektronik. Bahagian mekanikal yang terlibat adalah semasa membuat
perkakasan. Bahagian elektrik adalah semasa membina litar yang boleh membekalkan
kuasa dan pada masa yang sama, mengesas semula bateri. Bahagian elektronik adalah
semasa proses fabrikasi. Dalam projek ini, prototaip di rekabentuk dengan menggunakan
dua kaedah yang berbeza. Kaedah pertama menggunakan pencetus gegelung dan kaedah
kedua menggunakan suis reed. Pemutar dan magnet yang digunakan pada kedua-dua
kaedah adalah tetap. Hasil kajian menunjukkan bahawa kaedah yang kedua iaitu dengan
menggunakan suis reed telah berjaya tidak seperti kaedah pertama. Kecekapan mesin ini
adalah 36.626% dan kelajuan sudut pemutarannya adalah 36 rpm. Voltan dan arus yang
terhasil apabila dilekatkan motor DC adalah masing-masing 150 mV dan 30 mA.
_______________________________________________________________________________________________________
The purpose of this project is to build a prototype that can generate electricity by
using a moving system. The moving part is made from magnet and coil. A few magnet is
put at the rotor. To make the rotor keep rotating, there must be electric current pass
through the solenoid. The solenoid is made by winding a coil on the coil spool and fill
with iron core in the middle of the spool. Therefore, a circuit is built to allow the
movement of current from power battery to pass through the solenoid and at the same
time, it will charge the other battery. This prototype is designed based from three features.
Mechanical, electrical and electronic features. The mechanical part involved in making
the hardware. The electrical part is to build the circuit that can supply power and at the
same time, charge back the battery. The electronic part is the fabrication process. In this
project, the prototype is design with two different method. The first method is using
trigger coil and the second method is using reed switch. The rotor and the magnet is fixed
for both method. The result shows that the second method which is by using reed switch
is success unlike the first method. The efficiency of this machine is 36.626% and the
angular speed of the rotor is 36 rpm. The voltage and current generated after coupled a
DC motor is 150 mV and 30 mA respectively.