Projek pra-siswazah ini mencadangkan rekabentuk antenna penyalun
dielektrik segi empat. Julat frekuensi yang dikehendaki adalah di antara 2GHz
dan 4GHz dengan frekuensi operasinya berada pada nilai 3GHz. Selain itu,
antena yang efisien harus mempunyai kehilangan balikan di bawah tahap -10dB.
Antena ini direka dengan menggunakan bahan yang mempunyai nilai pemalar
dielektrik yang amat rendah dan dikenali sebagai RO4003C™. Nilai pemalar
elektriknya hanya 3.38. Selain itu, bahan dielektrik yang digunakan dikenali
sebagai Bismuth Titanate, Bi3Ti4O12. Nilar pemalar elektriknya adalah setinggi
90. Selepas antenna ini dibuat, prestasinya telah diuji. Proses ini dijalankan
dengan bantuan alatan pengukur yang terdapat di makmal RF. Antara alatan
pengukur yang digunakan adalah Network Analyzer dan Material Analyzer.
Selepas itu, perbandingan dan analisa telah dibuat untuk memerhatikan prestasi
dan keberfungsian antenna yang direkabentuk. Dengan menetapkan objektif untuk merekabentuk antenna yang
beroperasi pada frekuensi 3GHz, projek ini dilaksanakan dengan lancar dan
memperolehi frekuensi operasi 2.7GHz untuk kedua-dua model simulasi dan
model antenna yang dibuat. Perbezaan kehilangan balikan antara kedua-dua
simulasi dan antenna yang diuji hanya sebanyak 3.4%. Parameter lain seperti
gandaan dan tahap efisien mencapai nilai yang memuaskan. Maka, projek prasiswazah
ini berjaya disempurnakan dengan baik.
_______________________________________________________________________________________________________
This undergraduate project proposes the design of a Rectangular
Dielectric Resonator Antenna (DRA). The targeted frequency range is between
2GHz and 4GHz with its resonant frequency to be around 3GHz. Besides that,
the return loss of the antenna aims to have a return loss lower than -10dB to
justify for an efficient antenna feed. The DRA was designed using a low dielectric
constant substrate material that is known as RO4003C™. Its dielectric constant
is only 3.38. On the other hand, the ceramic dielectric was fabricated using high
dielectric constant Bismuth Titanate, Bi3Ti4O12, which has value as high as 90.
After fabrication, the antenna is tested for its performance. This was done with
the help of measuring equipment in the RF laboratory such as network analyzer
and the material analyzer. Comparisons were then conducted to observe the
efficiency of the designed antenna. With objective of designing a DRA with 3GHz resonant frequency, the
project was completed successfully with the resonant frequency occurring around
2.7GHz both in simulation and measurement results. At the resonant frequency
of 2.7GHz, the return losses only differs only 3.4% from each other. Other
parameters such as gain, directivity and efficiency achieved a satisfactory value.
Thus, the design of the Dielectric Resonator met the desired requirement and is
successfully done.